Printronix L5520 - Manual (Page 109)

Flash Messages
109
ERROR: DC PROGRAM
NOT VALID There is no emulation software
installed in the DC flash
memory, or the emulation
software in the DC flash
memory is corrupted. Power off the printer and
download the program
again. If the message
persists, contact your
service provider.
ERROR: DRAM AT
ADDRESS
xxxxxxxx
The printer found a defective
DC DRAM memory location. Contact service
provider.
ERROR: FLASH TYPE
IS NOT SUPPORTED This type of flash memory
SIMM is unsupported, or the file
system in the DC flash memory
is corrupted. Power off the printer and
download the program
again. If the message
persists, contact your
service provider.
ERROR: FLASH
DID NOT PROGRAM The printer encountered an
error while trying to program the
DC flash memory. Power off the printer and
download the program
again. If the message
persists, contact your
service provider.
ERROR: FLASH
NOT DETECTED The printer could not find any
DC flash memory. Contact service
provider.
ERROR: NO DRAM
DETECTED The printer could not find any
DC DRAM. Contact service
provider.
ERROR: NVRAM
FAILURE The non-volatile memory has
failed. Contact your service
provider. (Do NOT
attempt to replace
NVRAM.)
ERROR: PROGRAM
NEEDS MORE DRAM The printer requires more DC
DRAM memory in order to run
the downloaded program or in
order to use the downloaded
files. Use a smaller emulation
program or have your
service provider add DC
DRAM to the controller
board.
Table 2. Flash Messages