Printronix L5520 - Manual (Page 50)

Chapter 3 Save Configuration
50
Saving New Configurations
IMPORTANT If you do not save your configuration, all of the new values will
be lost when you turn off the printer.
You can save up to eight different configuration sets to meet eight
unique print job requirements. For example:
Config. 0: Factory Default (This cannot be altered.)
Config. 1: Selects Image Width of 4 inches
Selects Paper Length of 10 inches.
Config. 2: Selects Image Width of 8 inches
Selects Paper Length of 11 inches.
The configurations are saved and stored in flash memory for later
use.
NOTE: If the “Protect Config.” option is enabled, the new
configuration is not saved unless the existing configuration
has been deleted.
Save Configuration
Save configuration allows you to save up to eight different
configurations to meet different print job requirements.
Configuration 0 is a factory-preset configuration that cannot be
changed or saved.
Perform the following steps to save a new configuration:
Step Press LCD Message
1. Place the printer offline. OFFLINE
CONFIG. CONTROL
2. Unlock the ENTER key. ENTER SWITCH
UNLOCKED
ON LINE
+