Printronix L5520 - Manual (Page 110)

Chapter 3 Loading Flash Memory
110
ERROR: PROGRAM
NEEDS MORE FLASH The printer requires more DC
flash memory in order to run the
downloaded program or in
order to use the downloaded
files. Optimize the flash file
system. If the message
persists, use a smaller
emulation program, or
have your service
provider add DC flash
memory to the controller
board.
ERROR: PROGRAM
NOT COMPATIBLE The downloaded program is not
compatible with the printer. Use the correct
emulation software
option(s) for this printer
model.
ERROR: PROGRAM
NOT VALID The printer did not detect an
emulation program in DC flash
memory, or the emulation
program in DC flash memory is
present but corrupted. Power off the printer and
download the program.
If the message persists,
contact your service
provider.
ERROR: SECURITY PAL
NOT DETECTED The security PAL is not present
or has failed. Contact your service
provider
ERROR: SHORT AT
ADDRESS
xxxx
Hardware failure in DC DRAM
or in controller board circuitry. Contact your service
provider.
ERROR: WRITING
TO FLASH Hardware or software fault in
DC flash memory. Power off the printer and
download the program
again. If the message
persists, contact your
service provider.
ERROR: WRONG
CHECKSUM The printer received the
complete program or data file,
but the checksum did not
match. The data was corrupted
during download. Power off the printer and
download the program
again.
Table 2. Flash Messages