Installing under linux, Cards supported, Enhanced features – Perle Systems Adaptors User Manual
Page 78: Known limitations

FAST Serial Adaptors User Guide
Installing under Linux
Page 78
Chapter 2 Installing drivers and host cards
Installing under Linux
Cards Supported
The driver has been rewritten to support the following Perle products only:
•
4-port AT-Fast
•
8-port AT-Fast
•
16-port AT-Fast (restricted modem control)
•
4-port PCI-Fast
•
8-port PCI-Fast
•
16-port PCI-Fast (restricted modem control)
•
16-port PCI-Fast (full modem control)
•
4-port PCI-RAS
•
8-port PCI-RAS
Enhanced Features
The range of baud rates has been extended to 460800 bits/sec. The on-chip hardware and
software flow control capabilities of the 16C654 UART are utilised to reduce host load.
Known Limitations
1. The driver cannot be installed as a module on multi-processor systems. It can only be
installed as a statically-linked driver. On single-processor systems it can be installed
statically linked or as a module.
2. Data can be lost if multiple ports are run simultaneously at 230400 or 460800 bits/sec.