Perle Systems Adaptors - Manual (Page 46)

FAST Serial Adaptors User Guide
Installing under SCO OpenServer 5
Page 46
Chapter 2 Installing drivers and host cards
General setup procedure for SCO OpenServer 5
The general procedure for installing FAST cards under the SCO OpenServer 5 operating
system is as follows;
1. Before commencing the installation process under SCO OpenServer 5, configure your
system as described in Initial configuration under SCO OpenServer 5 on page 47 .
2. Install any PCI host cards and distribution cables or boxes you require into your system.
See Installing host cards and distribution accessories on page 79 .
3. Install any AT cards and distribution cables or boxes you require into your system. See
Installing host cards and distribution accessories on page 79 .
4. Install the driver software onto your system using the procedures given in Installing the
driver software on page 49 .
5. You can then enable login access using the procedures given in Enabling login
access on page 50 .
6. If required, remove any host cards you want from your system. See Removing host
cards on page 103 .
Note
If you are installing AT-FAST hardware you should examine your system
configuration and determine non-conflicting I/O addresses and IRQs for use with
each ISA card.
See Suggested hardware settings for AT-FAST on page 48 .
Note
For information on upgrading or re-installing drivers, see
Reinstalling or
upgrading software on page 50 .
To remove drivers, see Removing the driver software on page 50