Perle Systems Adaptors User Manual
Page 100
FAST Serial Adaptors User Guide
Installing host cards and distribution accessories
Page 100
Chapter 2 Installing drivers and host cards
5. Using jumper
JP5
select the flow control type to
RTS
or
DTR
as required.
Mechanical
installation
You can now install the AT host card in your system. To do this proceed as follows;
6. Turn off the power to your system and disconnect the mains supply.
7. Remove the system cover to expose the inside of the connector panel for host cards.
8. Insert the AT card you want to install into a vacant host card slot and secure in place as
shown in the next picture.
until you have installed all the AT cards you want.
Note
The exact location of host card slots varies for different systems, for exact mechanical
details of your system, refer to your system documentation.
Warning
Dangerous voltages exist inside computer systems. Before
installing host cards in your system, turn off the power supply
and disconnect the mains lead.
Caution
Full anti-static precautions should be taken when handling host
cards.