Lanier LP222cn - Manual (Page 301)

Monitoring and Configuring the Printer
182
access
Use the “access” command to view and configure access control. You can also
specify two or more access ranges.
❖ View settings
msh> access
❖ Configuration
msh> access range “start-address end-address”
• represents a target number between 1 and 5. (Up to five access ranges
can be registered and selected.)
Example: to specify accessible IP addresses between 192.168.0.10 and
192.168.0.20:
msh> access 1 range 192.168.0.10 192.168.0.20
❖ Access control initialization
msh> access flush
• Use the “flush” command to restore the default settings so that all access
ranges become “0.0.0.0”.
❒ The access range restricts computers from use of the printer by IP address.
If you do not need to restrict printing, make the setting “0.0.0.0”.
❒ Valid ranges must be from lower (start address) to higher (end address).
❒ Up to five access ranges can be specified. The entry is invalid if the target
number is omitted.
❒ You cannot access Web Image Monitor from a restricted IP address.
appletalk
Use the “appletalk” command to view and configure Appletalk parameters.
❖ View settings
msh> appletalk
• [2] means “active” and [0] means “inactive”.
• The default is [2].
❖ Changing PAP timeout configuration
msh> appletalk ptimeout value > 0
• Timeout value becomes effective.
msh> appletalk ptimeout value = 0