Lanier LP222cn - Manual (Page 192)

Preparing for Printing
73
B
Click the icon of the printer you want to use.
C
On the [File] menu, click [Properties].
D
Click the [Accessories] tab.
If options in the [Change Accessories] tab are disabled, bidirectional connection
is enabled. In this case, no change is necessary for option settings.
❒ If you are using the RPCS printer driver, click the [Change Accessories] tab.
❒ If you are using the PS printer driver, click the [Device Settings] tab.
E
Select options installed from the [Option] area, and then make the neces-
sary settings.
F
Select the total amount of the memory in [Total Memory:], when the option-
al SDRAM module is added.
G
Under [Paper source tray settings], click and highlight the tray to be used,
and then select the appropriate size, position, and type for the tray. Se-
lect the [Tray locking] check box to exclude the tray from the targets of au-
tomatic tray selection.
H
Click [OK] to close the printer properties dialog box. Click the [Defaults]
tab, and then click [Change Accessories] to display the option selection.