Konica Minolta BIZHUB PRO bizhubPRO920 - Manual (Page 87)

Supplies & Handling 4
bizhub PRO 920 4-9
Su
ppli
e
s &
Hand
ling
Ch
apt
e
r 4
4.2 Loading Tabbed Sheets in Tray
Tabbed sheets can be used if “Tabbed” is indicated in the tray information
area of the Machine Status Screen.
!
Detail
To use tabbed sheets for copying, enter the Utility menu to specify the
tray paper type. For details, see page 1-2 of POD Administrator’s refer-
ence.
Loading Tabbed Sheets in Tray 1, 2, and 3
0 The tab extension width should be 12.5 mm or less.
0 Be sure that the machine is powered ON before withdrawing the tray.
1
Withdraw the tray specified as tabbed sheets.
– Be sure to withdraw the tray completely until it stops.
2
Open the paper feed roller.
3
Place the tabbed sheets on the tray as illustrated above.
4
Move the side guide plates and rear guide to the edge of the paper.
5
Close the paper feed roller, then push in the tray until it locks into place.
Example: 3 tabbed sheets loaded in position for one finished set
Printed
side
Example: 9 tabbed sheets loaded in position for 3 finished sets
Printed
side
1st TABs
2nd TABs
3rd TABs
1st TAB 2nd TAB
3rd TAB
1st TAB
2nd TAB
3rd TAB
3rd TAB
2nd TAB
1st TAB
Rear
Front
Rear
Front
ONE FINISHED SET
3 FINISHED SETS