Konica Minolta BIZHUB PRO bizhubPRO920 - Manual (Page 337)

Finishing / Paper Fold 12
bizhub PRO 920 12-11
Finishin
g / Pap
e
r
F
o
ld
Ch
ap
te
r 12
12.4 Sorting / Stapling Copies
The FS-509/FS-516/FS-604 Finisher has a primary (main) tray and a second-
ary (sub) tray, each of which has the basic output modes as described below.
Output to the primary (main) tray:
-
Sort: Outputs multiple copies of the original set.
- Group: Groups together multiple copies of each original.
- Offset: Outputs each sorted/grouped set offset by approx. 30 mm upon
exit.
- Staple: Staples each sorted/grouped set with one staple at the corner or
two staples along the edge.
2
Reminder
If large sized paper (e.g. 11”×17” or A3) or paper specified as “Exclusive
K” delivered to the primary (main) tray shows excessive curl, perform the
setting described below. (For Finisher FS-604 only)
(1) Take out the paper guide from the guide holder which is located on
the rear side of Finisher FS-604, then install it to the primary (main) tray.
(2) When copying job is completed, remove the paper guide from the pri-
mary (main) tray, and return it to its original position.
Sort
Group
Offset Staple
Sort
Group
Example:
Make 3 copied sets
from 4 original sheets
Offset by 30 mm
Offset by 30 mm