Kenwood TM-G707 - Manual (Page 71)

65
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
CLONE
Clone is used to copy exactly all transceiver settings to
another TM-G707 transceiver. Everything set or stored
in one transceiver is copied into another transceiver at
one time. The cable for connecting the two TM-G707
transceivers is available as an option (E30-3326-05);
contact a KENWOOD service center.
Note:
◆ Before connecting the cable, switch off the power to the two
transceivers.
◆ The two TM-G707 transceivers must be the same market versions to
use the Clone function.
◆ If “ERROR” appears on the display, you might have performed
incorrect operations. Switch off the power to the two transceivers
and exactly follow the procedures given in this manual.
1 Connect one end of the appropriate cable to the
DATA connector of one transceiver.
2 Connect the other end of the cable to the DATA
connector of another transceiver.
3 Configure one transceiver as required.
• This transceiver is referred to as the “source
transceiver” hereafter.
4 On the source transceiver, press [F]+[REV]+[ ].
• “CLONE” appears.
2 1
3
5 On the target transceiver, press [F]+[REV]+[ ].
• “CLONE” appears.
6 On the source transceiver, press [CALL].
• Data transfer starts.
• “SEND” appears.
• When data transfer finishes, “END” appears on the
source transceiver.
• If data transfer fails, “ERROR” appears on the source
transceiver.
7 Switch the two transceivers off.
8 Disconnect the cable from the two transceivers.
The connection cable equipped with 6-pin mini DIN plugs
is wired as below:
DATA connector DATA connector
DE
PKD (NC)
PKS/RxD
PR9
PRI
SQC/TxD
E (GND)
DE
PKD (NC)
PKS/RxD
PR9
PRI
SQC/TxD
E (GND) NC: No connection