Kenwood TM-G707 - Manual (Page 61)

55
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■ Tone Frequency Number Entry
1 Select the desired band.
2 Press [TONE] to activate the Tone or CTCSS
function.
3 Press [F], [T.SEL].
• The current tone frequency appears.
4 Press the Mic key re-programmed with Enter.
• “- -” appears.
5 Use the Mic keypad to enter the Tone No.
corresponding to the desired tone frequency.
• Consult the tables given in pages 24 and 47 to find
out how the Tone Nos. correspond to the tone
frequencies.
• To select Tone No. 3 (74.4 Hz), for example, enter
“03”.
• If you press any key other than [0] ~ [9], or if you do
not make the next entry within 10 seconds, the
previous frequency display will be restored.
CHANGING FREQUENCY STEP SIZE
Choosing the correct step size is essential in order to
select your exact receive frequency using the Tuning
control or Mic [UP]/ [DWN]. The default step size on the
VHF band is 5 kHz (U.S.A./ Canada) or
12.5 kHz (Europe/ General). The default on the UHF
band is 25 kHz no matter which market version.
1 Press [VFO] to select VFO mode.
2 Select the desired band.
3 Press [F], [STEP].
• The current step size appears.
4 Turn the Tuning control, or press Mic [UP]/ [DWN], to
select the desired step size.
• The selectable step sizes are 5, 6.25, 10, 12.5, 15, 20,
25, and 50 kHz.
5 Press [OK] to complete the setting.
Note: Changing between step sizes may correct the displayed
frequency. For example, if 144.995 MHz is displayed with a 5 kHz step
size selected, changing to a 12.5 kHz step size corrects the displayed
frequency to 144.975 MHz.
1 2