Kenwood TM-G707 - Manual (Page 46)

40
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
VFO SCAN
VFO Scan allows you to scan all frequencies from the
lowest frequency to the highest frequency on the band.
The current frequency step size {page 55} is used.
1 Select the desired band.
2 Press [VFO] (1 s).
• The 1 MHz decimal blinks while scanning is in progress.
• Scan starts at the frequency currently displayed.
• To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan), or press Mic [UP]/ [DWN].
3 To quit VFO Scan, press any key other than [MHz]
and Mic [UP]/ [DWN].
Note: The squelch must be closed for Scan to function.
MEMORY SCAN
Memory Scan allows all memory channels containing
data to be scanned.
1 Press [MR] (1 s).
• The 1 MHz decimal blinks while scanning is in progress.
• Scan starts with the channel last recalled.
• To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan), or press Mic [UP]/ [DWN].
2 To quit Memory Scan, press any key other than Mic
[UP]/ [DWN].
Note:
◆ At least 2 or more memory channels must contain data and must not
be locked out.
◆ The squelch must be closed for Scan to function.
◆ The L1 to L6 and U1 to U6 memory channels and the priority channel
are not scanned.
◆ You can also start Memory Scan when in Channel Display mode.
While Scan is being interrupted, the channel number blinks.
◆ If you select “ONE” using Menu No. 4 (MR), memory channels on
only the current band will be scanned; otherwise, memory channels
on both VHF and UHF bands will be scanned.
1 s 1 s