Kenwood TM-G707 - Manual (Page 12)

6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
KENWOOD
FM DUAL BANDER TM-G707
PACKET EQUIPMENT CONNECTIONS
If you intend to use this transceiver for Packet operation,
you will need the following equipment.
• Personal computer with communications software
• Terminal Node Controller (TNC)
• TNC power supply
• RS-232C cable
• 6-pin mini DIN plug (optional PG-5A)
For the DATA connector pins, refer to “PACKET
OPERATION” {page 61}.
Note:
◆ Do not share a single power supply between the transceiver and the
TNC.
◆ Keep as wide a separation between the transceiver and computer as
practical to reduce noise-pickup by the transceiver.
◆ One end of the optional PG-5A cable has not been connectorized.
Attach the appropriate connector that mates with the TNC connector.
TNC power
supply
RS-232C cable
TNC
PG-5A cable
TM-G707
KENWOOD FM DUAL BANDER TM-G707
KENWOOD FM DUAL FM DUAL
ACCESSORY CONNECTIONS
■ External Speaker
If you plan to use an external speaker, choose a
speaker with an impedance of 8 Ω. The external
speaker jack accepts a 3.5 mm (1/8") diameter mono
(2-conductor) plug. Recommended speakers include
the SP-50B and SP-41.
■ Microphone
To communicate in the voice modes, plug a 600 Ω
microphone equipped with an 8-pin modular
connector into the modular socket on the front panel
of the transceiver. Press firmly on the plug until the
locking tab clicks.
Transceiver
power supply