Kenwood TM-G707 - Manual (Page 31)

25
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■ Automatic Repeater Offset
(U.S.A./ Canada/ Europe Only)
This function automatically selects an offset direction
and activates the Tone function, according to the
frequency that you select on the VHF band. The
transceiver is programmed for offset direction as
shown below. To obtain an up-to-date band plan for
repeater offset direction, contact your national
Amateur Radio association.
U.S.A. and Canada versions
This complies with the standard ARRL band plan.
European versions
Note: Automatic Repeater Offset does not function when Reverse or
CTCSS is ON. However, pressing [REV] after Automatic Repeater
Offset has selected an offset (split) status, exchanges the receive and
transmit frequencies.
1 Select the VHF band.
2 Press [MNU] to enter Menu mode.
3 Select Menu No. 7 (ARO).
4 Press [OK], then switch the function ON (default)
or OFF.
5 Press [OK] again to complete the setting and exit
Menu mode.
2
1
+ − − − + S S S S
144.0 145.5 146.4 147.0 147.6
145.1 146.0 146.6 147.4 148.0 MHz
S: Simplex
S S
S: Simplex
–
144.0 146.0 MHz 145.8 145.6