Kenwood TM-G707 - Manual (Page 55)

49
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
STORING DTMF NUMBERS FOR AUTOMATIC DIALER
To store a DTMF number with a maximum of 16 digits in
any of 10 dedicated DTMF memory channels, follow the
procedure below.
Note: Audible DTMF tones from other transceivers near you may be
picked up by your microphone. If so, this could prevent the function from
working correctly.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 29 to 38 (DTMF) corresponding to
the desired memory channel .
3 Press [OK].
• The display for entering a DTMF number appears.
4 Use the keypad to enter the digits of the number to
be stored.
• The corresponding DTMF tones are heard.
• If you enter an incorrect digit, press [VFO] to erase all
digits entered.
5 Press [OK] to complete the entry and exit Menu
mode.
CONFIRMING STORED DTMF NUMBERS
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 29 to 38 (DTMF) corresponding to
the desired memory channel.
3 Press [MR].
• The number stored in the channel scrolls across the
display accompanied by DTMF tones from the speaker.
4 Press [MNU] to exit Menu mode.
TRANSMITTING STORED DTMF NUMBERS
To transmit a stored DTMF number, follow the procedure
below.
1 Press Mic [PTT]+ Mic [PF].
2 Press a single key [0] to [9] to select the desired
channel.
• The number stored in the channel scrolls across the
display accompanied by DTMF tones from the speaker.
• After the transmission, the frequency display is restored.