Kenwood TM-G707 - Manual (Page 62)

56
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
DISPLAY DIMMER
■ Manual Dimmer Change
You can manually change the display illumination to
suit the lighting conditions where you are operating.
Press [DIM] to select from 5 levels, including OFF.
Note: Selecting OFF automatically switches Auto Dimmer Change
ON.
■ Auto Dimmer Change
This function increases the display intensity one step
brighter for approximately 5 seconds when you press
a front panel button or Mic key, or turn the Tuning
control. No change occurs if you have selected the
brightest level.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 2 (A.DIM).
3 Press [OK], then turn the Tuning control to switch
the function ON (or OFF).
4 Press [OK] again to complete the setting and exit
Menu mode.
BEEP VOLUME CHANGE
The transceiver beeps each time you press a front panel
button or Mic key. You can change the beep volume or
turn it off.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 16 (BEEP).
3 Press [OK], then turn the Tuning control to select the
volume from levels 1 to 7 and OFF.
• The default is level 5.
4 Press [OK] again to complete the setting and exit
Menu mode.
DISPLAY DEMONSTRATION
By initiating this function, various pre-programmed
displays appear. You still can normally use the
transceiver in this mode. Pressing a front panel button
or Mic key, or turning the Tuning control restores the
operating display immediately. If there is no button/key
entry or Tuning control adjustment for approximately
12 seconds, the transceiver reverts back to
Demonstration mode.
Press [F]+[ ] to switch the function ON (or OFF).