Kenwood TM-G707 - Manual (Page 38)

32
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
MEMORY
➡ VFO TRANSFERS
Transferring the contents of a memory channel or the
Call channel to the VFO can be useful if you want to
search for other stations or a clear frequency, near the
selected memory channel or Call channel frequency.
1 Recall the desired memory channel or the Call
channel.
2 Press [F], [VFO].
• The entire contents of the memory channel or the Call
channel are copied to the VFO. VFO mode is selected
after the transfer is completed.
Note:
◆ A transmit frequency from an odd-split memory channel or odd-split
Call channel is not transferred to the VFO. To transfer a transmit
frequency, press [REV], then press [F], [VFO].
◆ Lockout status and memory names are not copied from a memory
channel to the VFO.
CHANNEL DISPLAY FUNCTION
When this function is switched ON, the transceiver
displays only a memory channel number instead of a
frequency.
Press [LOW]+[ ] to switch this function ON (or OFF).
When in Channel Display mode, you cannot use the
following functions:
• VFO Select
• Programmable Memory
Recall
• Memory Channel Store
• Memory ➞ VFO Transfer
• Freq. Step Size Change
• Easy Operation Select
• Programmable Memory
Reset
• MHz Function Select
• Programmable Memory
Store
• Call Channel Store
• Memory Channel Clear
• VFO Scan
• Partial/ Full reset
Note:
◆ You cannot switch this function ON if you have stored frequencies in
no memory channels.
◆ When in Channel Display mode, you may want to recall only memory
channels of the desired band. Before pressing [LOW]+[ ], select
“ONE” in Menu No. 4 (MR), then select the desired band.
1
2