Kenwood TM-G707 - Manual (Page 49)

43
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■ Using Program Scan
1 Select a frequency equal to or between the
programmed scan limits.
2 Press [VFO] (1 s).
• The 1 MHz decimal blinks while scanning is in
progress.
• Scan starts at the frequency currently displayed.
• To reverse the scan direction, turn the Tuning
control clockwise (upward scan) or counterclockwise
(downward scan), or press Mic [UP]/ [DWN].
3 To quit Program Scan, press any key other than
[MHz] and Mic [UP]/ [DWN].
Note:
◆ The squelch must be closed for Scan to function.
◆ If the frequency step of the current VFO frequency differs from
that of the programmed frequencies, you cannot use Program
Scan.
◆ If the frequency steps of the lower limit and upper limit differ, you
cannot use Program Scan.
◆ If the current VFO frequency is within more than one
programmed scan range, the range stored in the smallest
channel numbers is used.
CALL/VFO SCAN
Use Call/VFO Scan to monitor both the Call channel and
the current VFO frequency on the selected band.
1 Press [VFO] to select VFO mode.
2 Select the desired band.
3 Select the desired frequency.
4 Press [CALL] (1 s) to start Call/VFO Scan.
• The 1 MHz decimal blinks while scanning is in progress.
5 To quit Call/VFO Scan, press any key other than Mic
[UP]/ [DWN].
CALL/MEMORY SCAN
Use Call/Memory Scan to monitor both the Call channel
and the desired memory channel.
1 Recall the desired memory channel.
2 Press [CALL] (1 s) to start Call/Memory Scan.
• The 1 MHz decimal blinks while scanning is in progress.
• The Call channel on the same band as of the selected
memory channel is used for Scan.
3 To quit Call/Memory Scan, press any key other than
Mic [UP]/ [DWN].
Note: The memory channel last used is scanned even if it has been
locked out.