Kenwood TM-G707 - Manual (Page 45)

39
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
SCAN RESUME METHODS
Before using Scans other than Priority Scan, it’s
necessary to decide under what condition you want your
transceiver to continue scanning after detecting and
stopping for a signal. You can choose Time-Operated
mode or Carrier-Operated mode. The default is Time-
Operated mode.
• Time-Operated mode
Your transceiver stops scanning when detecting a signal,
remains there for approximately 5 seconds, and then
continues to scan even if the signal is still present.
• Carrier-Operated mode
Your transceiver stops scanning when detecting a signal
and remains on the same frequency until the signal drops
out. There is a 2 second delay between signal drop-out and
scan resumption to allow time for any responding stations to
begin transmitting.
Note: To temporarily stop scanning and monitor weak signals, press and
hold the Mic PF key assigned the Monitor function {page 51}. Release
the key to resume scanning.
■ Selecting Scan Resume Method
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 10 (SCAN).
3 Press [OK] , then select Time-Operated (default)
or Carrier-Operated.
4 Press [OK] again to complete the setting and exit
Menu mode.
1
2