Kenwood TM-G707 - Manual (Page 47)

41
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■ Locking Out Memory Channels
Memory channels that you prefer not to monitor while
scanning, can be locked out.
1 Recall the desired memory channel.
2 Press [MNU] to enter Menu mode.
3 Select Menu No. 3 (MR.L.O.).
4 Press [OK], then switch Lockout ON (or OFF).
5 Press [OK] again to complete the setting and exit
Menu mode.
When you recall a locked out memory channel, a star
appears above the memory channel.
Note: The L1 to L6 and U1 to U6 memory channels and the priority
channel cannot be locked out.
MHz SCAN
MHz Scan allows you to scan a 1 MHz segment of the
band. The current 1 MHz digit determines the limits of
the scan. For example, if the current frequency is
438.400 MHz, then MHz Scan would scan from
438.000 MHz to 438.975 MHz. The exact upper limit
depends on the step size selected.
1 Select the desired band.
2 Press [VFO] (1 s) to start VFO Scan first.
3 Press [MHz] to start MHz Scan.
• The 1 MHz decimal blinks while scanning is in progress.
• Scan starts at the frequency currently displayed.
• To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan), or press Mic [UP]/ [DWN].
4 To quit MHz Scan, press any key other than [MHz]
and Mic [UP]/ [DWN].
1 s
1
2