Kenwood TM-G707 - Manual (Page 70)

64
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
CROSS-BAND OPERATION
This transceiver is capable of receiving signals on one
band and transmitting signals on another band. This
function, however, is neither Cross-band Repeater nor
Full Duplex. Cross-band Operation does not repeat
signals originating from one band, using another band,
and it does not receive and transmit signals
simultaneously. This function is useful, for example,
when joining in a group talk via a Cross-band Repeater.
Participants in a group talk need to set a receive and
transmit frequency on different bands so as not to miss
any conversations within the group.
Note: It is illegal to use Cross-band Repeater in some countries. Check
with your local regulations.
1 Press [BAND] to select the band for transmitting.
2 Select the appropriate transmit frequency.
3 Press [BAND] to select another band.
• This band will be used for receiving.
4 Select the appropriate receive frequency.
5 Press [F], [ ] to enter Cross-band Operation mode.
• A cross icon appears.
6 To exit Cross-band Operation mode, press [F], [ ]
again.
Note:
◆ You can use only 144 MHz and 430/ 440 MHz bands to perform
Cross-band operation.
◆ When in Cross-band Operation mode, pressing [BAND] switches the
receive and transmit band.
KEN WO OD FM D UAL BAN DER TM- G70 7
Cross-band
Repeater
TX: 146.500 MHz
RX: 443.500 MHz
146.500 MHz
443.500 MHz
146.500 MHz
443.500 MHz
TM-G707