Kenwood TM-G707 User Manual
Page 18
12
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
!4
!4
!4
!4
!4 MNU button
Selects the Menu mode {page 19}.
!5
!5
!5
!5
!5 PM button
Selects the Programmable Memory mode {page 36}.
!6
!6
!6
!6
!6
(POWER) switch
Switches the transceiver ON or OFF {page 15}.
!7
!7
!7
!7
!7 Microphone connector
Insert the 8-pin modular connector plug until the
locking tab “clicks”.
!8
!8
!8
!8
!8 DATA connector
Connect a Terminal Node Controller (TNC) for Packet
operation. Accepts a 6-pin mini DIN plug {page 6}.
REAR PANEL
q
q
q
q
q Antenna connector
Connect an external antenna {page 5}. When making
test transmissions, connect a dummy load in place of
the antenna. The antenna system or load should
have an impedance of 50 Ω. The TM-G707E accepts
a male N-type connector and other versions accept a
male PL-259 connector. This transceiver has only
one antenna connector because of a built-in duplexer.
w
w
w
w
w Power Input 13.8 V DC cable
Connect a 13.8 V DC power source. Use the
supplied DC power cable {pages 3 and 4}.
e
e
e
e
e Speaker jack
If you wish, connect an optional external speaker for
clearer audio. This jack accepts a 3.5 mm (1/8")
diameter, 2-conductor plug. See page 6 for more
information. The right jack is unavailable.
UP
DC 8 V, 200 mA max.
GND
STBY (PTT)
GND (MIC)
MIC
NC: No connection
DWN