Reverse function – Kenwood TM-G707 User Manual
Page 32
26
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
REVERSE FUNCTION
After setting a separate receive and transmit frequency,
you can exchange these frequencies using the Reverse
function. While using a repeater, this function allows you
to check the signal strength of a station accessing the
repeater. If the station’s signal is strong, move to a
simplex frequency to continue the contact and free up
the repeater.
Press [REV] to switch the Reverse function ON
(or OFF).
• “R” appears when the function is ON.
Note:
◆
If pressing [REV] places the transmit frequency outside the allowable
transmit frequency range, then pressing Mic [PTT] causes an error
beep to sound; transmission is inhibited.
◆
If pressing [REV] places the receive frequency outside the receive
frequency range, an error beep sounds and no reversal occurs.
◆
Automatic Repeater Offset does not function while Reverse is ON.
◆
You cannot switch Reverse ON or OFF while transmitting.