Konica Minolta 7130 - Manual (Page 24)

Requirements for Safe Use (continued)
1-6
Environment
CAUTION: Prevention of Fire
Do not install near flammable materials, curtains or
volatile combustibles, that can catch or cause fire.
CAUTION: Prevention of Short Circuit
Do not install the copier where it could be splashed
with rain water, or water from a tap, to avoid a
short circuit.
CAUTION: Temperature and Humidity
• Keep away from direct sunlight, heat sources
such as stoves, cool air from an air conditioner
and hot air from a heater.
• Avoid any environment that is outside the range
shown below:
50 to 86°F (10 to 30°C) in temperature
10 to 80% in humidity
CAUTION: Ventilation
• Install the machine in a well-ventilated place.
• Keep away from dust or corrosive gases. These materials may cause poor image quality.
• During use, the machine generates ozone in an insufficient amount to cause any
hazard to the human body.
However, if the machine is used in a poorly ventilated room, many copies are made,
or more than one copier is used at the same time, an odor may be detected. Ensure
adequate ventilation for a comfortable working environment.
CAUTION: Vibration
Do not install on a floor which is subject to vibration or is
not level.
CAUTION: Transportation
Be sure to contact your service representative when
moving or transporting the machine. If you move the
machine Memory unit installed, machine trouble may be
caused by vibration.