Konica Minolta 7130 - Manual (Page 188)

Repeating Automatically or Selecting Repeating Times
(Repeat: AUTO/ Repeat Mode) (continued)
8-50
8-50
9.
Position original.
For AUTO mode original, open the document feeder, then position the original FACE
DOWN on the platen glass.
For 2 Repeat, 4 Repeat or 8 Repeat mode original, RADF is also available.
HINT
See the illustration on p. 8-47 for details.
Reminder!
When AUTO mode is selected, Non-Image Area Erase functions automatically.
DO NOT close the document feeder.
10.
Press [START].
CAUTION
When the finisher / paper exit / inner tray capacity is exceeded
due to the print quantity selected, remove the copied sets as
they exit; otherwise, mishandled paper will occur.
DETAILS
The AUTO mode may not operate properly if the lighting in the work place
is directly over the platen glass. In this case, consult your service repre-
sentative about an appropriate place for installation.