Sanyo PLC-WXE46 - Manual (Page 45)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
45/65
9.5 PC Adjust Status Read Command
9.5.1 CR_FSYNC Command
Command "CR_FSYNC”[CR]
Details Get Fine Sync value
Response
Acceptable “000_%a”[CR]
%a “0000”~“0031”
Unacceptable
“Error Code”[CR] ----- When the command is invalid due to
condition such as Input source
“?”[CR] -------------------- When unclear command is received
9.5.2 CR_TDOTS Command
Command “CR_TDOTS”[CR]
Details Get Total Dots value
Response
Acceptable “000_%a”[CR]
%a
“nnnn”~“mmmm”
(nnnn = Display Dots + Horizontal Position)
(mmmm= Maximum value depends on input signal)
Unacceptable
“Error Code”[CR] -------- When the command is invalid due to
condition such as Input source
“?”[CR] ----------------------- When unclear command is received
9.5.3 CR_CLAMP Command
Command “CR_CLAMP”[CR]
Details Get Clamp value
Response
Acceptable “000_%a”[CR]
%a
“0001”~“nnnn”
(“nnnn” depends on input signal)
Unacceptable
“Error Code”[CR] -------- When the command is invalid due to
condition such as Input source
“?”[CR] ----------------------- When unclear command is received
9.5.4 CR_H – POS Command
Command “CR_H - POS”[CR]
Details Get Horizontal Position value
Response
Acceptable “000_%a”[CR]
%a
“0000”~“nnnn”
(nnnn = Total Dots - Display Dots)
Unacceptable
“Error Code”[CR] -------- When the command is invalid due to
condition such as Input source
“?”[CR] ----------------------- When unclear command is received