Sanyo PLC-WXE46 - Manual (Page 30)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
30/65
8.8 Lamp Command
8.8.1 CF_LAMPH Command
Command “CF_LAMPH_%1”[CR]
%1 “RST”
Details
Reset total lamp running time
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.8.2 CF_LAMPMODE Command
Command “CF_LAMPMODE_%1”[CR]
%1
“NORMAL” ------- Set lamp to Normal mode status
“ECO” ------------- Set lamp to ECO mode status
“UP” --------------- Switch Lamp mode forward.
(NORMAL
ECO NORMAL )
“DN” --------------- Switch Lamp mode in negative order
(ECO
NORMAL ECO )
Details
Select Lamp Mode
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]