Sanyo PLC-WXE46 - Manual (Page 35)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
35/65
8.10.11 CF_P-MANE Command
Command “CF_P MANE_%1”[CR]
%1
“OFF” --------------------------------- Set Power Management to OFF
“READY” ----------------------------- Set Power Management to Ready
“SHUTDOWN” --------------------- Set Power Management to Shut Down mode
“UP” ------------------------------ Switch Power management setting
Off → Ready → Shutdown → Off
“DN” ------------------------------ Switch Power management setting
Off → Shutdown → Ready → Off
Details
Set/Cancel Power Management
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.10.12 CF_P-MANETIME Command
Command “CF_P-MANETIME_%1”[CR]
“01” ~ ”30” ----------------------- Directly select setting time by the minute
“UP” ------------------------------- Plus one minute (01
→ 02 → → 30 → 01)
“DN” ------------------------------- Minus one minute(30 → 29 → → 01 → 30)
Details
Set Power Management time
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.10.13 CF_ON-STA Command
Command “CF_ON STA_%1”[CR]
%1
“ON” --------------------------- Set Power On Start to ON
“OFF” ------------------------- Set Power On Start to OFF
“UP” --------------------------- Switch setting (On
→ Off → On → )
“DN” --------------------------- Switch setting (On → Off → On → )
Note) “UP” and “DN” behave the same.
Details
Set/Cancel Power ON Start
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]