beautypg.com

Sanyo PLC-WXE46 User Manual

Page 21

background image

PLC-WXE46/WXL46

Expand Serial Command Functional Specifications

21/65

8.5.4

CF_H – POS Command

Command “CF_H-POS_%1”[CR]

%1

“0000~nnnn” --- Directly select Horizontal Position setting value

“nnnn” shows maximum value, it is current Total Dots value - Display Dots value

“UP” -------------- Current Horizontal Position setting value + 1
“DN” -------------- Current Horizontal Position setting value - 1

Details

Set Horizontal Position value of PC signal.
The value set by this command will not be saved to projector. Therefore, when
turning into Stanby mode or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.

Response

Acceptable

“000”[CR]

Unacceptable “101”[CR] ---- when Input for Video is selected

8.5.5

CF_V – POS Command

Command “CF_V-POS_%1”[CR]

%1

“0000~nnnn” --- Directly select Vertical Position setting value

“nnnn” shows maximum value, it is current Total Line value - Display Line value

“UP” -------------- Current Vertical Position setting value + 1
“DN” -------------- Current Vertical Position setting value – 1

Details

Set Vertical Position value of PC signal
The value set by this command will not be saved to projector. Therefore, when
turning into Stanby mode or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.

Response

Acceptable

“000”[CR]

Unacceptable “101”[CR] ---- When Input source is Video system

8.5.6

CF_DDOTS Command

Command “CF_DDOTS_%1”[CR]

%1

“0256”~”nnnn” --- Directly select Display Dots setting value

“nnnn” shows maximum value, it is current Total Dots value - Horizontal

Position value
Even number is available and when odd number is set, it is rounded out.

“UP” -------------- Current Display Dots setting value + 2
“DN” -------------- Current Display Dots setting value – 2

Details

Set Display Dots value of PC signal
The value set by this command will not be saved to projector. Therefore, when
turning into Stanby mode or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.

Response

Acceptable

“000”[CR]

Unacceptable “101”[CR] ---- When Input for Video is selected