Sanyo PLC-WXE46 - Manual (Page 14)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
14/65
6.9 Other Status Read Command
Status read command Item
CR_STATUS[CR] Get setting status of Projector behavior
CR_SIGNAL[CR] Get Signal Status if there is a signal or not
CR_VMUTE[CR] Get setting status of No Show
CR_FREEZE[CR] Get setting status of Freeze
CR_PTIMER[CR] Get the operating status of Presentation Timer
CR_TEMPWARN[CR] Get if temperature is close to abnormal temperature
CR_TEMP[CR] Get current temperature status
CR_TEMPFAIL[CR]
Get temperature when sensors approach abnormal
temperature
7. Error Code Table
Error Code Contents
?
-When the received data cannot be decoded
-Parameter determination error (digit number error,
including invalid value, etc.)
101 The function is not available in the selected Mode
102 Selected value is out of range (Not reflected)
103
Command mismatched to Hardware (command for
Optional function which is not installed)
201
When reached upper or lower limit of increasing or
decreasing data
301
Command cannot be executed during capturing
display. Resend the command after a while
302
Command cannot be executed during Auto PC
operation. Resend the command after a while
402
Command cannot be executed during PIN code
operation. Resend the command after a while.
Note) These error codes are applied to Expand Command, not to Basic Command