Sanyo PLC-WXE46 User Manual
Page 33

PLC-WXE46/WXL46
Expand Serial Command Functional Specifications
33/65
8.10.4 CF_LOGO Command
Command “CF_LOGO_%1_%2”[CR]
%1
“0000”-”9999” ----------------- Set LOGO PIN CODE directly
%2
“OFF” ---------------------------- Disable Logo function
“DFLT” --------------------------- Display Default Logo
“USER” -------------------------- Display Captured Logo
“UP” --------------- Switch Logo setting in positive order
(OFF
→ DFLT → User → OFF →
)
“DN” --------------- Switch Logo setting in negative order
(OFF
→ User → DFLT → OFF →
)
Details
Set / Cancel Logo
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
%1--- Set LOGO PIN CODE
- When LOGO LOCK is in operation
PIN CODE is correct ------------------ Command is valid (Acceptable)
PIN CODE is incorrect ---------------- Command is invalid (Error Code “102”)
PIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)
-When LOGO LOCK is not in operation
PIN CODE is within %1 range ------ Command is valid
PIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)
Note) Receiving correct LOGO PIN CODE while LOGO LOCK
is in operation
enables to change LOGO setting, but it does not release LOGO LOCK. (LOGO
LOCK continues.)
Projector returns Error Code “101” by receiving USER in %2 when capture has
not operated.
Response
Acceptable
“000”[CR]
Unacceptable “Error Code”[CR]
8.10.5 CF_CEIL Command
Command “CF_CEIL_%1”[CR]
%1
“ON” ------------------------ Set Ceiling to ON
“OFF” ----------------------- Set Ceiling to OFF
Details
Set/Cancel Ceiling setting.
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
Response
Acceptable
“000”[CR]
Unacceptable “Error Code”[CR]
8.10.6 CF_REAR Command
Command “CF_REAR_%1”[CR]
%1
“ON” --------------------------- Set Rear to ON
“OFF” ------------------------- Set Rear to OFF
Details
Set/Cancel Rear setting.
When Rear is ON, image is left/right reversed.
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Response
Acceptable
“000”[CR]
Unacceptable “Error Code”[CR]