Sanyo PLC-WXE46 - Manual (Page 32)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
32/65
8.10 Setting Command
8.10.1 CF_LANG Command
Command “CF_LANG_%1”[CR]
%1
“ENG” --------------------------- Select English
“DEU” --------------------------- Select German
“FRA” --------------------------- Select French
“ITA” ----------------------------- Select Italian
“ESP” ---------------------------- Select Spanish
“POR” --------------------------- Select Portuguese
“NED” --------------------------- Select Dutch
“SVE” --------------------------- Select Swedish
“RUS” --------------------------- Select Russian
“CHI” ---------------------------- Select Chinese
“KOR” --------------------------- Select Korean
“JPN” --------------------------- Select Japanese
“FIN” ---------------------------- Select
Finnish
“POL” --------------------------- Select Polish
“HUN” -------------------------- Select
Hungarian
“ROM” -------------------------- Select Romanian
Details
Set language for OSD
The language set by this command is stored in EEPROM and its setting is
effective after ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.10.2 CF_BBACK Command
Command “CF_BBACK_%1”[CR]
%1
“ON” ----------------------------- Select Blue Back
“OFF” ---------------------------- Cancel Blue Back
“UP” ------------------------------ Switch setting (On
→ Off → On → )
“DN” ------------------------------ Switch setting (On → Off → On → )
Note) “UP” and “DN” behave the same.
Details
Set / Cancel Blue Back
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.10.3 CF_DISP Command
Command “CF_DISP_%1”[CR]
%1
“ON” ----------------------------- Select Display
“OFF” --------------------------- Cancel Display
“CNTDWNOFF” -------------- Count down OFF
“UP” --------------- Switch Display mode in positive order
On → Count down OFF → Off → On →
“DN” --------------- Switch Display mode in negative order
On → Off → Count down OFF → On →
Details
Set / Cancel Display
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]