Sun Microsystems Sun Fire V490 - Manual (Page 150)

122 Sun Fire V490 Server Administration Guide • August 2004
What Next
To power on the system, complete this task:
■ “How to Power On the System” on page 122
How to Power On the System
Before You Begin
Do not use this power-on procedure if you have just added any new internal option
or external storage device, or if you have removed a storage device without
replacing it. To power on the system under those circumstances, you must initiate a
reconfiguration boot. For those instructions, see “How to Initiate a Reconfiguration
Boot” on page 138.
You can also use RSC software to power on the system. For details, see:
■ Sun Remote System Control (RSC) 2.2 User’s Guide
Caution – Never move the system when the system power is on. Movement can
cause catastrophic disk drive failure. Always power off the system before moving it.
Caution – Before you power on the system, make sure that all access panels are
properly installed.
What to Do
1. Turn on power to any peripherals and external storage devices.
Read the documentation supplied with the device for specific instructions.
2. Turn on power to the ASCII terminal or local graphics terminal, if present.
3. Open the media door.
Use the system key to unlock the media door.