Sharp MD-C2H User Manual

Page 9

(Continued)

■

Remote control

●

When inserting or removing the batteries, push them towards
the

battery terminal.

●

Installing the batteries incorrectly may cause the unit to mal-
function.

Precautions for battery use:

●

Insert the batteries according to the direction indicated in the
battery compartment.

●

Replace all old batteries with new ones at the same time.

●

Do not mix old and new batteries.

●

Remove the batteries if they are weak or if the unit will not be
used for long periods of time. This will prevent potential dam-
age due to battery leakage.

Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).

Notes concerning use:

●

Replace the batteries if the operating distance is reduced or if
the operation becomes erratic.

●

Periodically clean the transmitter LED on the remote control
and the sensor on the main unit with a soft cloth.

●

Exposing the sensor on the main unit to strong light may in-
terfere with operation. Change the lighting or the direction of
the unit.

●

Keep the remote control away from moisture, excessive heat,
shock, and vibrations.

■

Main unit operation buttons

The main unit operating buttons are common to all functions
(MD/CD/Tuner/Tape).
Some buttons may have no function, depending on the mode
selected.
When a button indicator is lit, the corresponding button can be
used.

■

Jog dial

The jog dial is used to select CD or MD track numbers, adjust
the clock, select a station from memory, and enter characters.

●

When the jog dial is turned one step, it will stop at an angle
of about 15

. This has the same effect as pressing the

3 /

2 / 4

button on the remote control once.

●

If the jog dial is turned further, it has the same effect as press-
ing the

3 / 5

2 / 4

button on the remote control

repeatedly.

■

To change the brightness of the display

Press the ON/STAND-BY button to turn the power on.

Press the DIMMER button.

●

The display will become dimmer, and the MD illumination will
go out.

To return to the original brightness:

Press the DIMMER button again.

Note:

●

The brightness setting of the display is maintained even after
the unit has entered stand-by mode.

●

2 "AA" size batteries
(UM/SUM-3, R6, HP-7
or similar)

Remote sensor

0.2 m - 6 m
(8" - 20’)

Jog dial

(Main unit)

(Remote control)

When bright

When dark

MD-C2H(SUK) TINSE0238AWZZ