Sharp MD-C2H - Manual (Page 47)

HK
(Continued)
ENTER
SLEEP
2
3
Caution:
In the following cases, the timer recording function will
not work.
When recording on a MiniDisc:
● When a MiniDisc has not been inserted.
● When a playback-only MiniDisc is inserted.
● When the MiniDisc you inserted is protected against
accidental erasure.
● When there is no recording space left on the Mini-
Disc you have inserted (when the "TOC FULL
∗ " or
"DISC FULL" messages appear).
When recording on a tape:
● When no tape is inserted.
● When the tape is protected against accidental erasure.
Jog dial
■
Sleep operation
The radio, compact disc and MiniDisc can all be turned
off automatically.
1
Play the desired sound source.
2
Press the SLEEP button.
● "SLEEP" will flash.
● If you do not need to change the time, go to step
3.
To change the sleep time:
Whilst the sleep time is displayed, turn the jog dial to
adjust the time.
(Maximum: 2 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during
the sleep operation. (1-minute intervals)
3
Press the ENTER button.
4
The unit will enter the stand-by mode automatically
after the preset sleep time has elapsed.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by
mode.
The sleep operation can also be cancelled as follows if
you can not set the unit to the stand-by mode during
recording.
①
Press the SLEEP button.
● "SLEEP" will flash.
②
Within 5 seconds, press the SLEEP button again.
● The sleep operation will be cancelled. ("SLEEP" will
go off.)
Notes:
● Once the sleep time is set, it will remain the same
duration until the setting is changed.
● The sleep functions of this unit cannot be used to
control equipment connected to this unit. You must
use the sleep functions of the other equipment, if it
has them.
■
Simultaneous sleep and timer operation
To use sleep and timer playback in combination:
①
Perform steps 1 - 12 on page 44 "Timer playback".
②
Perform steps 1 - 4 of the "Sleep operation" on this page.
To use sleep and timer recording in combination:
①
Perform steps 1 - 12 on page 45 "Timer recording".
②
Perform steps 1 - 4 of the "Sleep operation" on this page.
Sleep timer setting
Tim er p layba ck
(record) setting Timer playb ack
(record) start
1 minute - 2 hours Desired time
Sleep operation will
automatically stop. End time
Note:
● The sleep timer will perform timer playback or timer recording
from the source you are listening to, until the power is turned
off.
MD-C2H(SUK) TINSE0238AWZZ
46