Sharp MD-C2H - Manual (Page 24)

(Continued)
■
To manually recall the stations stored in mem-
ory
Each time you turn the jog dial one step the channel number will
change.
● After the channel number has been displayed for 2 seconds,
the frequency for that channel will appear for 2 seconds, and
then the station name will appear.
■
To switch the display
Each time the DISPLAY MODE button is pressed whilst an FM
station is tuned in, the display will switch as follows:
Station
name (PS) Programme
type (PTY) Radio text
(RT)
DISPLAY
MODE
Frequency
When the station you are tuning in is not an RDS station or even
if it is an RDS station but it is very weak signal, the display will
change in the following order:
"NO PS" "NO PTY" "NO RT" Frequency
Notes:
● "NO PS", "NO PTY" or "NO RT" will flash for about 5 seconds,
and then the frequency will be displayed.
● The display can only be switched whilst tuned to the FM band.
■
Notes for Radio text
● The radio text for 10 characters will be displayed steadily for
4 seconds and then it will scroll across the display.
● If you tune into a station which is not broadcasting any radio
text, even if it is an RDS station, when you switch to the radio
text position "NO RT" will be displayed.
● Whilst radio text data is being received or when the text con-
tents change, "RT" will be displayed.
■
Notes for RDS operation
If any of the following events occur, it does not mean that the
unit is faulty.
● "PS", "NO PS" and a station name appear alternately, and the
unit does not operate properly.
● If a particular station is not broadcasting properly or a station
is conducting tests, the RDS reception function may not work
properly.
● When you receive an RDS station whose signal is too weak,
information like the station name may not be displayed, even
if "RDS" is lit.
(Main unit operation)
Jog dial
(Main unit operation)
MD-C2H(SUK) TINSE0238AWZZ
23