Sharp MD-C2H - Manual (Page 7)

HK
PREPARATION FOR USE
1 2 3
1 2 3
● Unplug the AC power lead from the AC socket before con-
necting or disconnecting any component.
■
Aerial connection
Supplied FM aerial
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the strongest
signal can be received.
Supplied AM loop aerial
Connect the AM loop aerial wire to the AM ANTENNA socket.
Position the AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf, etc., or attach it to a stand
or a wall with screws (not supplied).
Notes:
● Do not place the aerial on the main unit as it may result in
noise pickup from the internal digital electronics.
Place the aerial away from the unit for better reception.
● If the AM loop aerial and the FM aerial wire are placed near
the AC power lead, interference may result.
External FM aerial
Use an external FM aerial if you require better reception.
Consult your dealer.
■
Speaker connection
Connect each speaker wire to the SPEAKER terminals as shown.
Use speakers with an impedance of 6 ohms or more, as lower
impedance speakers can damage the unit.
Caution:
● Connect the black wire to the minus (
−
) terminal, and the red
wire to the plus (+) terminal.
● Do not mix the right channel and left channel wiring when
connecting the speakers to the unit.
● Do not let bare speaker wires touch each other as this may
damage the amplifier and/or speakers.
Note:
● Attach the cushions to the bottom of the speaker to prevent it
from sliding.
FM aerial
AM loop aerial
External FM aerial
Right speaker Left speaker
Red Red
Black Black
MD-C2H(SUK) TINSE0238AWZZ
6