Sharp MD-C2H - Manual (Page 21)

(Continued)
■
To specify station names and select stations
manually (station select)
You can received for a desired station by specifying the station
name (BBC R1, BBC R2, etc.) from among the stations that have
been stored in memory.
(ASPM is convenient for storing stations in memory.)
Before starting this operation, you must store one or more station
names in memory.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button.
3
Press the TUNER (BAND) button to select the FM ST or FM
band.
4
Press the STATION button.
● "STATION" and "SELECT" will appear alternately for about 6
seconds.
5
Within 6 seconds, turn the jog dial on the main unit or press
the PRESET (
X or W ) button on the remote control to select
a desired station name you want.
● Each time the button on the remote control is pressed, the
station name will appear. If the button is held down for more
than 0.5 seconds, the station name will continuously change.
6
Whilst the selected station name is flashing (within 6 sec-
onds), press the STATION button again.
● After the selected station name has been lit for 1 second, the
preset station which corresponds to the selected station name
will be recalled.
To cancel the station select operation:
Press the STATION button whilst "STATION" and "SELECT" ap-
pear alternately.
1
2,3
1
5
4
4 5
2,3
4
5
6
MD-C2H(SUK) TINSE0238AWZZ
20