Sharp MD-C2H - Manual (Page 52)

(Continued)
CD playback
SYMPTOM POSSIBLE CAUSE REMEDY
● Even though a disc has been loaded,
"CD NO DISC" is displayed.
● Playback stops in the middle of a track,
or playback is not performed properly.
● Playback sounds are skipped.
● The disc is loaded up-side down.
● The disc is very dirty.
● The disc which does not satisfy the
standards.
● Is the unit located near excessive vi-
brations?
● Has condensation formed inside the
unit?
● Load the disc with the correct side up.
● Clean the disc.
● Load the correct disc.
● Place the unit on a firm, level surface
free from vibration.
● Remove the disc and leave the power
turned on. The unit should function
properly in about 1 hour.
MD recording and playback
SYMPTOM POSSIBLE CAUSE REMEDY
● A recording cannot be made. ● Is the MiniDisc protected against ac-
cidental erasure?
● Did you try to make recording on a
playback-only MiniDisc?
● Can you see the "DISC FULL" or "TOC
FULL
∗ " message in the display?
(
∗
:Number or Symbol)
● Slide the accidental erase prevention
tab back to its original position.
● Replace it with a recordable disc.
● Put in another recordable disc with rec-
ording space on it.
● Even though a disc has been loaded,
"MD NO DISC" or "MD
∗∗ ERR" is dis-
played.
( ∗ :Number or Symbol)
● Playback sounds are skipped.
● The disc is very dirty.
● Is the unit located near excessive vi-
brations?
● Has condensation formed inside the
unit?
● Clean the disc.
● Place the unit on a firm, level surface
free from vibration.
● Remove the disc and leave the power
turned on. The unit should function
properly in about 1 hour.
Tape recording and playback
SYMPTOM POSSIBLE CAUSE REMEDY
● A recording cannot be made. ● Is the tape protected against accidental
erasure? ● Cover the accidental erase prevention
hole.
● Sound is skipped.
● Sound in high-frequency range cannot
be reproduced.
● Sound quivers.
● The tape is damaged.
● The capstan and pinch roller are very
dirty.
● Replace the tape.
● Clean the capstan and pinch roller.
● The cassette cannot be ejected. ● Did a power failure occur? ● Wait until the power is supplied.
Radio reception
SYMPTOM POSSIBLE CAUSE REMEDY
● Radios make unusual noise consecu-
tively. ● The unit is placed near the TV or com-
puter.
● The aerial direction is not placed
properly.
● When the unit receives a radio broad-
cast near a TV set, a computer or a
wordprocessor, it may pick up noise. If
this happens, try to move the unit from
the place where the noise is picked up.
● Correct the aerial direction.
● The preset channel cannot be recalled. ● Did you erase the programmed sta-
tion?
● Did you leave the power lead un-
plugged for a long time?
● Preset the channel again.
● Redo programming.
Remote control
SYMPTOM POSSIBLE CAUSE REMEDY
● The remote control does not function
or does not operate properly. ● The batteries (polarity) are not inserted
properly.
● The batteries inside the remote control
are dead.
● The remote control is operated from an
incorrect distance or angle.
● Insert properly.
● Replace the batteries.
● Operate it within a range of 0.2 m (8")
to 6 m (20’) and within an angle of 15
°
to either side of centre.
● The power cannot be turned on from
the remote control. ● Is the AC power lead plugged in? ● Connect the AC power lead.
MD-C2H(SUK) TINSE0238WZZ
51