Sharp MD-C2H - Manual (Page 45)

HOW TO USE THE BUILT-IN TIMER
● Before setting the timer, make sure that the clock setting is
correct. (Page 9)
ENTER
TIMER
ON/
STAND-BY
2
3
4
5
7
6
■
Timer playback
Before timer playback, the following preparations are required.
● Load a CD, MD or tape.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TIMER button.
3
Within 5 seconds, press the ENTER button.
● The start time setting display will appear.
4
Within 10 seconds, turn the jog dial to set the hour to start,
and then press the ENTER button.
5
Within 10 seconds, turn the jog dial to set the minute to start,
and then press the ENTER button.
● If not set manually, the ending time will automatically be set
for one hour after the starting time.
6
Within 10 seconds, turn the jog dial to set the hour to stop,
then press the ENTER button.
7
Within 10 seconds, turn the jog dial to set the minute to stop,
then press the ENTER button.
8
Press the MD, CD, TUNER (BAND), TAPE or AUX button to
select the desired function.
When MD is selected:
● Continuous playback will start from MD 1.
When CD is selected:
● Continuous playback will start from the CD whose red frame
is flashing.
To specify a disc to start playback from, press one of the CD
PLAY 1
0 - 3 0 buttons. Then, press the ■ button.
When TUNER is selected:
● Tune in the radio station.
When is AUX is selected:
● Set the timer on the other equipment connected to this unit.
9
Rotate the VOLUME control to adjust the sound volume.
● Be careful not to turn the volume up too high.
10 Press the ON/STAND-BY button to enter the stand-by mode.
● The timer set indicator will light up.
11 When the timer start time is reached, timer playback will start.
12 When the timer end time is reached, timer playback will stop.
● " f PLAY" will disappear, and the timer mode will be cancelled.
The unit will enter the stand-by mode.
Notes:
● Timer playback and timer recording cannot be set at the same
time using the timer.
Use the timer in one mode or the other.
● The timer cannot control the component connected to the
AUX-IN sockets.
● When the CD or MD is played to the end, playback will stop
before the stop time.
If you wish to play to the stop time, set repeat play for the
CD or MD.
To change the programmed contents:
Start again from step 1.
To stop playback during timer playback:
Press the ON/STAND-BY button to enter the stand-by
mode.
To confirm the timer setting:
Press the TIMER button once.
● The turn-on time and the turn-off time will be displayed.
To cancel timer operation:
①
Press the ON/STAND-BY button to turn the power on.
②
Press the TIMER button repeatedly to turn off the timer, " f
PLAY" will go out.
Jog dial
MD-C2H(SUK) TINSE0238AWZZ
44