SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 273)

Wireless Interface Commands
7-103
Example
turbo
This command sets the wireless bridge to an enhanced mode
(not regulated in IEEE 802.11a) that provides a higher data rate
of up to 108 Mbps.
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless - 802.11a)
Command Usage
• The normal 802.11a wireless operation mode provides
connections up to 54 Mbps. Turbo Mode is an enhanced
mode (not regulated in IEEE 802.11a) that provides a higher
data rate of up to 108 Mbps. Enabling Turbo Mode allows
the wireless bridge to provide connections up to 108 Mbps.
• In normal mode, the wireless bridge provides a channel
bandwidth of 20 MHz, and supports the maximum number
of channels permitted by local regulations (e.g., 11 channels
for the United States). In Turbo Mode, the channel
bandwidth is increased to 40 MHz to support the increased
data rate. However, this reduces the number of channels
supported (e.g., 5 channels for the United States).
Example
AP(if-wireless a)#channel 36
AP(if-wireless a)#
AP(if-wireless a)#turbo
AP(if-wireless a)#