SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 251)

PPPoE Commands
7-81
ip pppoe
This command enables Point-to-Point Protocol over Ethernet
(PPPoE) on the Ethernet interface. Use the no form to disable
PPPoE on the Ethernet interface.
Syntax
ip pppoe
no ip pppoe
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
pppoe lcp
echo-failure Sets LCP echo timeout for the
PPPoE tunnel IC-E 7-85
pppoe local ip Sets local IP address for the PPPoE
tunnel IC-E 7-86
pppoe remote ip Sets remote IP address for the
PPPoE tunnel IC-E 7-86
pppoe username Sets the user name for the PPPoE
tunnel IC-E 7-87
pppoe password Sets the password for the PPPoE
tunnel IC-E 7-88
pppoe
service-name Sets the service name for the
PPPoE tunnel IC-E 7-89
pppoe restart Restarts the PPPoE connection with
updated parameters IC-E 7-89
show pppoe Shows information about the
PPPoE configuration PE 7-90
Command Function Mode Page