SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 204)

Command Line Interface
7-34
SNMP Commands
Controls access to this wireless bridge from management
stations using the Simple Network Management Protocol
(SNMP), as well as the hosts that will receive trap messages.
snmp-server community
This command defines the community access string for the
Simple Network Management Protocol. Use the no form to
remove the specified community string.
Syntax
snmp-server community string [ro | rw]
no snmp-server community string
• string - Community string that acts like a password and
permits access to the SNMP protocol. (Maximum length: 23
characters, case sensitive)
• ro - Specifies read-only access. Authorized management
stations are only able to retrieve MIB objects.
• rw - Specifies read/write access. Authorized management
stations are able to both retrieve and modify MIB objects.
Command Function Mode Page
snmp-server
community Sets up the community access string
to permit access to SNMP commands GC 7-34
snmp-server
contact Sets the system contact string GC 7-35
snmp-server
enable server Enables SNMP service and traps GC 7-36
snmp-server host Specifies the recipient of an SNMP
notification operation
GC 7-37
snmp-server
location Sets the system location string GC 7-38
show snmp Displays the status of SNMP
communications Exec 7-39