SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 113)

Advanced Configuration
6-37
Note: If you have upgraded system software, then you must reboot the
wireless bridge to implement the new operation code.
CLI Commands for Downloading Software from a TFTP Server –
Use the copy tftp file command from the Exec mode and then
specify the file type, name, and IP address of the TFTP server.
When the download is complete, the dir command can be used
to check that the new file is present in the wireless bridge file
system. To run the new software, use the reset board command
to reboot the wireless bridge.
AP#copy tftp file 7-41
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:1
TFTP Source file name:bridge-img.bin
TFTP Server IP:192.168.1.19
AP#dir 7-43
File Name Type File Size
-------------------------- ---- -----------
dflt-img.bin 2 1319939
bridge-img.bin 2 1629577
syscfg 5 17776
syscfg_bak 5 17776
262144 byte(s) available
AP#reset board 7-13
Reboot system now? : y