SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 100)

System Configuration
6-24
CLI Commands for RADIUS MAC Authentication – Use the
mac-authentication server command from the global
configuration mode to enable remote MAC authentication. Set the
timeout value for re-authentication using the mac-authentication
session-timeout command. Be sure to also configure
connection settings for the RADIUS server (not shown in the
following example). To display the current settings, use the show
authentication command from the Exec mode.
AP(config)#mac-authentication server remote 7-59
AP(config)#mac-authentication session-timeout 300 7-60
AP(config)#exit
AP#show authentication
7-60
Authentication Information
=========================================================
MAC Authentication Server : REMOTE
MAC Auth Session Timeout Value : 300 secs
802.1X : DISABLED
Broadcast Key Refresh Rate : 5 min
Session Key Refresh Rate : 5 min
802.1X Session Timeout Value : 300 secs
Address Filtering : DENIED
System Default : DENY addresses not found in filter table.
Filter Table
MAC Address Status
----------------- ----------
00-70-50-cc-99-1a DENIED
00-70-50-cc-99-1b ALLOWED
=========================================================
AP#