SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 249)

Filtering Commands
7-79
filter ethernet-type protocol
This command sets a filter for a specific Ethernet type. Use the
no form to disable filtering for a specific Ethernet type.
Syntax
filter ethernet-type protocol <protocol>
no filter ethernet-type protocol <protocol>
protocol - An Ethernet protocol type. (Options: ARP, RARP,
Berkeley-Trailer-Negotiation, LAN-Test, X25-Level-3, Banyan,
CDP, DEC XNS, DEC-MOP-Dump-Load, DEC-MOP,
DEC-LAT, Ethertalk, Appletalk-ARP, Novell-IPX(old),
Novell-IPX(new), EAPOL, Telxon-TXP, Aironet-DDP,
Enet-Config-Test)
Default
None
Command Mode
Global Configuration
Command Usage
Use the filter ethernet-type enable command to enable
filtering for Ethernet types specified in the filtering table, or the
no filter ethernet-type enable command to disable all filtering
based on the filtering table.
Example
Related Commands
filter ethernet-type enable (page 7-78)
AP(config)#filter ethernet-type protocol ARP
AP(config)#