SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 108)

System Configuration
6-32
Trap Destination Community Name – The community string sent
with the notification operation. (Maximum length: 23 characters;
Default: public)
CLI Commands for SNMP – Use the snmp-server enable
server command from the global configuration mode to enable
SNMP. To set read/write and read-only community names, use
the snmp-server community command. The snmp-server host
command defines a trap receiver host. To view the current SNMP
settings, use the show snmp command.
AP(config)#snmp-server enable server 7-36
AP(config)#snmp-server community alpha rw 7-34
AP(config)#snmp-server community beta ro
AP(config)#snmp-server host 10.1.19.23 alpha
7-37
AP(config)#exit
AP#show snmp
7-39
SNMP Information
============================================
Service State : Enable
Community (ro) : ****
Community (rw) : *****
Location : building-1
Contact : Paul
Traps : Enabled
Host Name/IP : 10.1.19.23
Trap Community : *****
=============================================
AP#