Sterling AquaSnap 30RA010-055 - Manual (Page 98)

CL-6
III. Unit Start-Up (cont)
PRESS ESCAPE KEY TO DISPLAY ‘OPT1’. PRESS DOWN ARROW KEY TO DISPLAY ‘OPT2’.
PRESS ENTER KEY.
RECORD CONFIGURATION INFORMATION BELOW.
OPTIONS2 (Options Configuration)
RSET (Reset Configuration Settings)
SUBMODE ITEM DISPLAY DESCRIPTION VALUE
OPT2 UNIT OPTIONS 2 CONTROLS
CTRL X CONTROL METHOD
SCNA XXX SCN ADDRESS
SCNB XXX SCN BUS NUMBER
BAUD X SCN BAUD RATE
LOAD X LOADING SEQUENCE SELECT
LLCS X LEAD/LAG CIRCUIT SELECT
LCWT XX.X ∆F HIGH LCW ALERT LIMIT
DELY XX MINUTES OFF TIME
ICE.M ENBL/DSBL ICE MODE ENABLE
CLS.C ENBL/DSBL CLOSE CONTROL SELECT
LS.MD X LOW SOUND MODE SELECT
LS.ST 00:00 LOW SOUND START TIME
LS.ND 00:00 LOW SOUND END TIME
LS.LT XXX % LOW SOUND CAPACITY LIMIT
SUBMODE ITEM DISPLAY DESCRIPTION VALUE
RSET RESET COOL TEMP
CRST X COOLING RESET TYPE
MA.DG XX.X °F 4-20 - DEGREES RESET
RM.NO XXX.X °F REMOTE - NO RESET TEMP
RM.F XXX.X °F REMOTE - FULL RESET TEMP
RM.DG XX.X °F REMOTE - DEGREES RESET
RT.NO XXX.X °F RETURN - NO RESET TEMP
RT.F XXX.X °F RETURN - FULL RESET TEMP
RT.DG XX.X °F RETURN - DEGREES RESET
DMDC X DEMAND LIMIT SELECT
DM20 XXX % DEMAND LIMIT AT 20 MA
SHNM XXX LOADSHED GROUP NUMBER
SHDL XXX % LOADSHED DEMAND DELTA
SHTM XXX MAXIMUM LOADSHED TIME
DLS1 XXX % DEMAND LIMIT SWITCH 1
DLS2 XXX % DEMAND LIMIT SWITCH 2
LLEN ENBL/DSBL LEAD/LAG CHILLER ENABLE
MSSL SLVE/MAST MASTER/SLAVE SELECT
SLVA XXX SLAVE ADDRESS
LLBL X LEAD/LAG BALANCE SELECT
LLBD XXX LEAD/LAG BALANCE DELTA
LLDY XXX LAG START DELAY
PARA YES/NO PARALLEL CONFIGURATION