SUPER MICRO Computer X6DHi-G2 - Manual (Page 70)

4-14
X6DH3-G2/X6DHi-G2 User's Manual
I/O Device Confi guration
Access the submenu to make changes to the following settings.
KBC Clock Input
This setting allows you to select clock frequency for KBC. The options are 6MHz,
8MHz, 12MHz and 16MHz.
Onboard COM 1
This setting allows you to assign control of Serial Port A. The options are Enabled
(user defi ned), Disabled, and Auto (BIOS- or OS- controlled).
Base I/O Address
Select the base I/O address for Serial Port A. The options are 3F8, 2F8, 3E8
and 2E8.
Interrupt
Select the IRQ (interrupt request) for Serial Port A. The options are IRQ3 and
IRQ4.
Onboard COM 2
This setting allows you to assign control of Serial Port B. The options are Enabled
(user defi ned), Disabled, Auto (BIOS controlled) and OS Controlled.
Mode
Specify the type of device that will be connected to Serial Port B. The options
are Normal, and IR (for an infrared device).
Base I/O Address
Select the base I/O address for Serial Port B. The options are 3F8, 2F8, 3E8
and 2E8.
Interrupt
Select the IRQ (interrupt request) for Serial Port B. The options are IRQ3 and
IRQ4.
Parallel Port
This setting allows you to assign control of the parallel port. The options are
Enabled (user defi ned), Disabled and Auto (BIOS-or OS- controlled).
Base I/O Address
Select the base I/O address for the parallel port. The options are 378, 278
and 3BC.
Interrupt
Select the IRQ (interrupt request) for the parallel port. The options are IRQ5
and IRQ7.